It’s been a while since we conquered the building of the shower but I’m just now over it! We thought when we pulled out the end cap and replaced it that the hard part was over, not hardly. Honestly, if we had known how much time it would take, we may have spent the big bucks for this insert from Inland RV! The original bath had the furnace duct and vent under the bathtub. This made building a strong base for the shower a challenge. The other tricky part was the walls. Dan wanted to curve the rear wall back in over the drain pipes that run along the wall to give him a little more elbow room. So, the left wall is one height, the right wall a little shorter, because we are at the rear of the trailer where it starts to curve down, and the back wall has an “s” curve in it. We both like a good challenge but this almost ate our lunch! Glad it’s done….moving on!